Skip to content

Как настроить модем dsl-2740u

Как настроить модем dsl-2740u

View and Download D-Link DSLU user manual online. DSLU Network Router pdf manual download.

Page of 76 Go. Page 9 - Information you will need about your DSL Page 10 - Information you will need about your LAN Version 1. Show quick links. Hide Hide permanently.

Как настроить модем dsl-2740u

Table of Contents. Dirl dual band gigabit cloud router pages. Visit www. Page 7 LAN side of the bridge, such as a PC, a server, a gateway device, such as a router, or similar firewall hardware. The IP address can be assigned in a number of ways.

Your network service provider will give you instructions about any additional connection software or NIC configuration that may be required.

User Manual

This setting can be changed in the WAN Setup window of the web management interface. The default subnet mask is This means that it can assign an IP address, subnet mask and a default gateway address to computers on your LAN. Page Hardware Description And Installation The device is handshaking with the physical layer of the office end.

A connection is set up with the physical layer of the office end. The device is under the Bridge mode or powered off. Green A connection is set up and no traffic is detected. Page 12 Power switch, which is used to power on or power off the host. Reset On the bottom side Press and hold the button for 1 second to restore the factory defaults. Step 4 Select the Obtain an IP address automatically button. Click OK to save the settings.

D-Link DSL-2740U

The page is shown as the figure appears on the right. Page 19 In this page, you can set the WAN interface. Step 6 There are types of Protocols to connect to internet in the drop-down list of protocol. According to your subscribed service from your ISP, select the protocols. Re-enter the password for confirmation. After setting, click Next. Page 22 SSID and password manually to join this wireless network. Choose an encryption mode for the wireless network.

Click Back to review or modify settings. Note: In each step of the Wizard page, you can click Back to review or modify the previous settings. Page 25 You can set the Idle Time as you need. Source The MAC address you want to clone. Page 28 PVC without the risk of cell loss. Its value ranges from 0 to The page shown in the following figure appears.

This page is used to configure PVC auto detect function, you can add or delete auto-pvc. Page 30 A dialog box prompts to reboot the router. Click OK. And then a pop-up dialog box shows the process of rebooting system. Step 3 When the rebooting system finished, a login window pops up. Input the username and password to log in the web configuration page. Step 3 If you do not change the Login password, click Skip to go to the next page.

Фольксваген тигуан можно ли поменять бампер на рестайлинг

Step 4 Set the system time and mode, and then click Next. You do not need to do any configuration in this step. Page 33 SSID and password manually to join this wireless network. In this page, you can add or configure WAN interface of your router. Page 36 You can set the Idle Time as you need.

Как настроить модем dsl-2740u

Step 5 After setting, click Add to add the new channel. Page 37 After setting, click Add to add the new channel. After adding a channel to the table, click in the PPPoE mode, the page shown in the following figure appears. In this page, you can modify parameters of this channel in PPPoE mode.

You can keep the default settings. It is recommended to keep it as defaults. This page allows you to configure the DHCP server. Page 42 After setting, click Apply Changes to save the settings. The page shown in the right figure appears.

  • Как сделать чтоб экран был темный на айфоне 5
  • This page allows you to reserve IP address for PC specified in this page. Page Wireless Setup APs overlap. Choose a channel from the drop-down list box. Choose the transmission power of the radio signal. It is Radio Power recommended to leave the default setting. You can also configure daylight saving to automatically adjust the time when needed.

    Click Apply Changes to save the settings. Page Advanced Choose the transmission rate of the wireless data from Data Rate the dropdown list. Page Access Control Access Point. When Deny Listed is selected, these wireless clients on the list will not be able to connect the Access Point.

    The page shown as the figure appears on the right. Page 49 - Based on the PIN of the client to be connected. And then click Start PIN button below. Page 50 This page allows you to set virtual access points VAP. You Allowed can select Any to choose all the services.

    D-Link Forums

    Page 52 IPv6 protocol. For the parameters description in this page, you can refer to the description of Access Control List. When you have finished, click the Apply changes button. The URL will be blocked during this time.

    Page 56 It allows you to create scheduling rules to be applied for URL block. Note: To use this feature, the time of router must be correct. Entries in the table are used to restrict certain types of data packets from your local network to Internet through the gateway. These filters are helpful in securing or restricting your local network. Page Dos Settings IP address is returned.

    Сколько будет лет если ты родился в 2003

    The page shown in the figure appears on the right. Page 60 DNS server. The key provided by DDNS provider. The system acts as a proxy for its hosts after you enable it. Page 63 Enter the trap IP address. The trap information is Trap IP Address sent to the corresponding host.

    Как сделать прицеп из задней балки ваз 2108

    Community Name The network administrators must use this password Read-only to read the information of this router. This page is used to configure the routing information. You can add or delete IP routes. Delete Select a row in the Rip Config List and click it to delete the row.

    The following table describes the parameters and buttons of this page: Field Description Input a local IP address. In this page, you can reset your router, backup settings, and update the settings of the router. Page Firmware Update In this page, you can change the username, password, and idle logout time. Page System Log Error or Notice or both will set the log flag.

  • Как сделать подвесной кокон своими руками
  • In this page, you can log out of the configuration page. Page Troubleshooting Troubleshooting This chapter provides solutions to problems that might occur during the installation and operation of the DSLU.